A hard case for the R36S retro gaming device. The case was designed to allow the buttons, joysticks and screen ample room inside the case. There is room to glue in a thin piece of felt above the screen for added protection.

There are two variants, one using 8x3mm magnets and another that uses a simple latching mechanism. The hinge fits a small length of filament.

The cases seen in the photographs were printed in Bambu ABS without supports with a 5mm brim at 0.20mm.

R36S Retro Handheld Hard Case

R36s Hard Case - Magnetic.3mf

R36s Hard Case - Latch.3mf

A TPU case for the Datafrog R36S Retro Handheld.

There are two designs attached, one that uses the included foam padding found in the box that shipped with the device, and another that is fully TPU with allowances for the screen, buttons and joysticks.

The original model allowed for space between the screen and the case, but I wanted a bit more padding with something more forgiving. The foam insert was the perfect size to start with!

Printed on a Bambulab P1S with hardened steel hot end and extruder with Orange Polymaker Polyflex TPU95.

Datafrog R36S Retro Handheld TPU Case

R36S-TPU-case-foam-insert.3mf

r36s-tpu-case-no-foam.3mf

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

stumpagness