This model is restricted by licensing terms.
View license.
48 Likes87 DownloadsFebruary 24, 2023
This model is restricted by licensing terms.
View license.
A balloon dog magnet.
This print requires 4 round magnets of width 6mm and height 3mm. To install the magnets, put a pauze just before the holes for the magnets are covered up when slicing.
Supports needed when printing. Be careful when removing the supports from the nose, this is the most fragile part of the model.
ALL The Crafty Maker designs are protected by Copyright Law. By downloading, YOU HAVE NO RIGHT to sell any digital files or reproductions from those files. If you want a commercial license to LEGALLY SELL 3D prints, you'll need a The Crafty Companion subscription.
Categories:
48 Likes87 DownloadsFebruary 24, 2023
This model is restricted by licensing terms.
View license.
48 Likes87 DownloadsFebruary 24, 2023
This model is restricted by licensing terms.
View license.