A mesmerizing table lamp inspired by wrapped candy. 3MF Multicolor files for bambulab AMS included!
What you need
- The two 3d printed parts
- A E27 (EU) or E26 (US) lamp socket kit that come with a screw-on attachment ring (check the images for a cross section with measurements). You can easily get the sockets with cord and switch on Amazon, Ikea or your local hardware store.
- A LED bulb
- Light-colored or transparent filament.
Instructions
- Check the provided images for measurements.
- Gather all required parts
- Print the design
- Insert the Socket (without bulb) from below
- Screw on the Ring from above into the base to secure the socket
- Insert the bulb
- Put on the shade
- Enjoy your new lamp!
Size assembled: 180 x 180 x 270 mm
Print settings Important: You cannot use any other bulb type than LED! LEDs still give off a little heat. Depending on the strength of your bulb the design might warm up slightly. The material you use has a certain heat deflection temperature before deformation. Make sure to build a safe product by verifying that the print is not affected by the amount of heat that your bulb emits! If you are uncertain or have little experience in building electrified products, please consult a professional! Usually, a strong LED bulb does not get hotter than 50 degrees Celsius while regular PLA does not deform under 58 degrees Celsius. Those are approximate numbers, and you need to verify that for own product selection.
Required build volume: 180 x 180 x 240 mm Material usage: 350 g
Material: PLA that can handle the heat that your bulb emits. Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 15% Build plate adhesion type: A brim for the shade